Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 19, 2007 11:59:10 GMT -5
THAT'S GREAT GADABRA. I'M ON YOUR CAR....FINALLY! You just increased it's value by 10K. Oh Dear. What have I done Your car is 1 of 1 now. I think you need to change your fender tag and add in the 3rd row..BOB.....
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 19, 2007 21:55:45 GMT -5
Looking good Bob. Are you going to paint the core support? The engine compartment on my 72 SE should be done by the end of this coming weekend. Of course, I have the advantage in that I am not working around an engine. Took about 3 hours just to get it degreased and scrubbed clean.
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 21, 2007 5:55:28 GMT -5
The radiator support area is the last one I have to do. As far as the headlight bucket adjustment there is one. This is for the passenger side grill area.
1. From the front looking at the grill, remove the 2 right mounting bolts. 2. Loosen all the other bolts. 3. The headlight bracket will adjust left, right and up and down. 4. Adjust the assembly, hand tighten the center bolts and fit the grill in place and check allignment. 5. Once the adjustment is correct, tighten the center upper and lower bolts. 6. Tighten the left upper and lower bolts. 7. Last ones to tighten are the right upper and lower.
The right side mounting arm is flexible to compensate for the unit being adjusted. Mine came out pretty good except for all the years it was out of adjustment and the rubber bezells are deformed a bit.
|
|
|
Post by Nacho-RT74 on Jun 21, 2007 13:08:48 GMT -5
so did came good then ?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Jun 21, 2007 13:15:39 GMT -5
Sure did.
|
|