|
Post by crazybillnavy on Sept 3, 2017 19:34:46 GMT -5
The wiring was all pulled out when I got my 74 so I am not sure how it's supposed to wire up. I got a new coil, distributor, control unit, regulator, and I am in the process of installing a painless harness. The coil has two red wires coming off of the positive and one yellow off of the negative. There is one black and one red wire coming off of the distributor. The painless instructions shows a few options for wiring up the distributor and stuff, just not sure. Any help would be great.
|
|
|
Post by goldrush on Sept 3, 2017 21:13:58 GMT -5
What engine, instrument panel, ect? You might consider picking up a shop manual off eBay. Sure has saved my butt a few times already..
|
|
|
Post by Nacho-RT74 on Sept 4, 2017 7:19:33 GMT -5
The original wiring must be hacked up because the original colors must be 14 gauge brown on + lead coming from ballast/ign switch and 16 gauge black traced yellow from ECU
|
|
|
Post by goldrush on Sept 4, 2017 18:13:09 GMT -5
+1
I should have looked in my shop manual before posting.. You are 100% correct Nacho! All body styles are indeed the same.
|
|
|
Post by Nacho-RT74 on Sept 4, 2017 19:00:23 GMT -5
Yea USUALLY color codes are more less the same, but there was some changes allong the years while more equipment were being added.
|
|
|
Post by crazybillnavy on Sept 6, 2017 20:29:06 GMT -5
Will this work? The original wiring was all pulled before I got it.
|
|
|
Post by Nacho-RT74 on Sept 6, 2017 22:24:03 GMT -5
Lol, whoever made that diagram used my base diagram LOL. I don't remember have made it for 74, just 72 and 73
Althought missed the choke control feed
Yes, thats the right one
|
|
|
Post by crazybillnavy on Sept 8, 2017 19:57:06 GMT -5
Got most of wired up, one more question. I have the two wires from the ECU (prongs 4 and 5)to the distributor with the connector on it. The distributor is aftermarket with a red wire and a black wire and no connector. How do I know which one hooks up to which?
|
|
|
Post by Nacho-RT74 on Sept 9, 2017 6:09:39 GMT -5
What kind of dist? Actually the replacements pickup coils ( even Mopars originals ) are orange/red and black wires.
|
|
|
Post by Nacho-RT74 on Sept 9, 2017 6:53:50 GMT -5
And if so, just searched an original diagram ( from an F body, but doesn't matter ) just to be sure once more the diagram I made is correctly "wired" on the ECU setup... should run to 4th pin
|
|