Post by Deleted on Jun 21, 2007 9:44:39 GMT -5
This is for the passenger side grill area, just the opposite for the drivers side. Remove the grill assembly first.
1. From the front looking at the headlights, remove the 2 right mounting bolts.
2. Loosen all the other bolts.
3. The headlight bracket will adjust left, right and up and down. The holes are large enough to compensate.
4. Adjust the assembly, hand tighten the center bolts and fit the grill in place and check alignment.
5. Once the adjustment is correct, tighten the center upper and lower bolts. Check alignment one more time.
6. Tighten the left upper and lower bolts.
7. Last ones to tighten are the right upper and lower.
The right side mounting arm is flexible to compensate for the unit being adjusted.
Mine came out pretty good except for all the years it was out of adjustment and the rubber bezels are deformed a bit.
1. From the front looking at the headlights, remove the 2 right mounting bolts.
2. Loosen all the other bolts.
3. The headlight bracket will adjust left, right and up and down. The holes are large enough to compensate.
4. Adjust the assembly, hand tighten the center bolts and fit the grill in place and check alignment.
5. Once the adjustment is correct, tighten the center upper and lower bolts. Check alignment one more time.
6. Tighten the left upper and lower bolts.
7. Last ones to tighten are the right upper and lower.
The right side mounting arm is flexible to compensate for the unit being adjusted.
Mine came out pretty good except for all the years it was out of adjustment and the rubber bezels are deformed a bit.